Sanding and chine logs glued

Chine logs cut down to length and glued to side panels.  Also completed a small amount of sanding before I need to buy more sanding pads.  Decided to use slightly smaller WRC chine logs, 43x17mm, instead of what the plans call for 45x19mm.  These still overlap the bottom by 10mm, as the plans call for.  I assume this will only effect the cutouts in the bulkheads, which I will need to remember to cut to the now smaller chine logs.  Once dry the chine logs will get 3 coats of epoxy then perhaps I will move on to shaping the stem...

Planning and pre-drilling

Clamping in process